Topics created by bmveee

FWIW... I may have found the cause of my 'pausing' issue. It appears that it was caused by a short of some kind on the extruder stepper motor, on the duet side(?). I repositioned the cables around the stepper motor connectors on the duet side and so far have not experienced this issue.

I also want to add that in addition to the issue being intermittent, it was present whether the rotating sensor was enabled or disabled (so it was not a problem with the sensor or sensor config).

@dc42

Ah, ok, that makes sense. Add it to the config-override.g manually. I just wanted to make sure that was an appropriate way to achieve the behavior I'm looking for.

Thanks!