yes it works with RC4. Thanks

I have tried 2.03RC3 with new PrusaSlicer 2.0. Filament used is not recognized. PrusaSlicer now output:

; filament used [mm] = 3363.4
; filament used [cm3] = 7.9

It works if I edit the file before sending it to the printer. I change to :

; filament used = 3363.4mm
; filament used [cm3] = 7.9

Do you have the reference for the connector and where I can buy a replacement ?

Thank you David.

Do you think it's fixable ? I didn't really realized it was so severe. It looks like the connector is affected and maybe a capacitor according to the fine white powder around.

hello,

for some days, I am unable to use my CORE XY C-Bot anymore. I experience huge voltage drops from 12V nominal to 9V or even 8V, with alarms appearing on the console. The power supply has been changed to no avail. My bed is powered by the main, so the only current sinks are the 5 motors (X, Y, 2x Z & E) and the hotend (12v E3D v6), plus a fan and a led strip that currently stay off.
The last days here where very hot and I noticed that before the problem arose, the board temperature sensor went to 50°C. Immediately removed the board cover but the problem is still here even if the temp is now reported to be 32°C in operation.

I am at a loss to fix that. I don't know if the board is suddendly faulty or if the hotend needs to be changed.

What can I check to assess the problem ?

Thank you

I was puzzled to find that Slic3r was dead on horizontal dimensions and Cura was off by several tenth of millimeter. I compared gcode from both and found out that Cura needs a line width of 0.45mm and an extrusion factor of 87.84% to match Slic3r

Hi,
Is there a way to avoid the firmware to stop trying to reconnect in case of losing the Wifi network ?
Every time my wifi router needs to reboot, which can take several minutes in order to reconnect the Wan network, the duet retries several times and then bails out. I then have to reissue a M552 command on the console to make connection great again. I have a macro but it's a PITA to do that every time.
Thanks

I was thinking of stall detection to calibrate z probe offset (G31 Z value). Is it possible to do that. I would continue to probe using my inductive sensor.

Yesterday I had a problem similar to yours. USB Ok but unable to connect DWC. Until I rebooted my wifi rooter…

Thank you. I was able to have a working homeall.g file by copying and tweaking the one in /sys-CoreXY
Regards