@jay_s_uk thanks that’s great news, looking forward to mess with the code.
Best posts made by CabalSoul
-
RE: Fly Screens are now Open Sourceposted in Accessories and Add-ons
-
RE: 3.4.0 b3 leaning printsposted in Beta Firmware
@t3p3tony In my case always -Y.
If i rotate the object it doesn't change anything. -
RE: Brim prints fine, then Extruder stepper motor starts stallingposted in Tuning and tweaking
@obezruki i can imagine two possibilities
1.Check your line width and flow in Cura, I had once problems printing TPU not realizing I had the line width set on to 0.04mm. Yours could be set too high.
- heat creep, your extruder doesn’t get enough cooling. Starts printing fine and then clogs. When it gets colder you can extrude fine again, for a time.