@supraguy

I am also having a problem with the height adjustment buttons. If I try to run auto calibration and check height manually, my height adjustment buttons will not refresh. If I run the calibration and exit and then use the homeall or home X Y or Z axis the button will not refresh.

Most functions seem to work but this is my first DWC so I have nothing to compare to. I have noticed that when I update the system files from the ZIP it creates a new folder and does not replace the system files. Otherwise, this is the first instance of functions not working

Duet Maestro 1.0, Firmware 1.02 RTOS
DWC 2.0.0 RC3

Issue: When running the manual delta calibration, the height adjust buttons freeze after pressing them one time. If I press the -0.5 adjustment the printer will move the correct distance and I will see a spinning wheel over the button, with the button grayed out. I cannot press the same adjustment button more than once. I use another adjustment height, but then see the same result, with all buttons grayed out with spinning wheels.

I have tried launching DWC from firefox and chrome and see the same problem.

The printer will run a print, and all other controls seem to work.

Thank you David! It was an auto-crossover problem.

** update

I've submitted a warranty claim to my distributor over two weeks ago. I got a reply asking for a list of what I have tried. Sent that in and followed up with a few reminder emails, but have not heard from them. So I decided to try my luck again with the Maestro. However, I am not able to use the web control. Here is what I have working. How can I get web control to work.

I have reimaged the SD card with the latest firmware and things seem to be working. I have confirmation that the I am running firmware 2.02.

m115
SENDING:M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 Maestro FIRMWARE_VERSION: 2.02(RTOS) ELECTRONICS: Duet Maestro 1.0 FIRMWARE_DATE: 2018-12-24b1

m39 to check if the sd card is reading (was not able to read this earlier)

m39
SENDING:M39
SD card in slot 0: capacity 0.51Gb, free space 0.50Gb, speed 15.00MBytes/sec, cluster size 8kb

M552 to enable network
m552
SENDING:M552
Network is enabled, configured IP address: 192.168.1.169, actual IP address: 192.168.1.169

m586, network set to use http

m586
SENDING:M586
HTTP is enabled on port 80
FTP is disabled
TELNET is disabled

When I access the ip address 192.168.1.169 from firefox I get a connection timed out error. I have ethernet and usb connected to my laptop.
What should I try next?

Thanks for any help you can send my way

I just opened my Duet 2 Maestro and I am having similar problems to original poster. I have current drivers and can connect to the duet via pronterface. I ran through the m552 p0.0.0.0; m552 s0; m552 s1; m552 p; and got the response "Bad IP address". I then checked m39 and saw that no SD card is present. I then used a new usb card, uploaded firmware 2.02 and ran through the same process and got the same results.

I feel stuck. what is my next step?