Posts made by CamperWill

So it looks like the Z stepper was bad, replaced it with an identical one and the mesh compensation is now working properly.. I'm guessing all the z-axis movement during the mesh compensation process was causing more missed steps then the simple repeat probes and non-mesh compensation prints that I did.

@oliof The Piezo board was re-tuned when I was calibrating everything after the RRF3 install.

The M208 is below, I can adjust this to allow negative values, would this also require adjusting the negative value in G31? I've seen the negative go down to maybe -0.8 on the bed compensation heatmap

M208 X0:215 Y-3.3:175 Z0:200

@oliof The subsequent mesh bed runs are pretty comparable and the repeatability test on various bed spots is near spot on. I can try reducing the dive speed to see if it helps but I think I did try to bring it down pretty significantly with no real change.

The overall issue I am running into is when printing with mesh compensation on, the print head isn't close enough to the plate... however with mesh compensation off it is at the intended height (only in a small area where the G30 was initiated).

Hey everyone, I have an old Hypercube I am working on resurrecting, it has a Piezo Orion and Duet 2 Wifi.

I updated the firmware and rebuilt the config files for the latest version (2 > 3.5.4) and am running into an issue getting the mesh compensation to work properly.

I am homing all axis and the probe itself is working as expected, however when I run G29 to do the mesh calibration it always returns the following:

G29
Warning: the height map has a substantial Z offset. Suggest use Z-probe to establish Z=0 datum, then re-probe the mesh.
20 points probed, min error -0.536, max error -0.222, mean -0.339, deviation 0.079
Height map saved to file 0:/sys/heightmap.csv

I am performing the G30 when homing the Z axis which puts the nozzle at the appropriate position, I am NOT trying to load a pre-saved heightmap, just create a fresh one.

Here is the relevant portions of config.g:

M558 K0 P8 C"!zprobe.in" R1 H2.5 F400 T3000 A10 S0.01
G31 P500 X0 Y0 Z-0.18
M557 X2:215 Y0:170 S50:50

Here is the homez (homeall contains the same pieces + X and Y):

G91 ; relative positioning
G1 H2 Z5 ; move Z relative to current position to avoid dragging nozzle over the bed
G90 ; absolute positioning

; home Z
var xCenter = move.compensation.probeGrid.mins[0] + (move.compensation.probeGrid.maxs[0] - move.compensation.probeGrid.mins[0]) / 2 - sensors.probes[0].offsets[0]
var yCenter = move.compensation.probeGrid.mins[1] + (move.compensation.probeGrid.maxs[1] - move.compensation.probeGrid.mins[1]) / 2 - sensors.probes[0].offsets[1]
G1 X{var.xCenter} Y{var.yCenter} F6000 ; go to bed centre
G30 ; probe the bed

After I do a home of Z I am doing a G29 and after that runs I experience the message above and the heightmap is all blue and a good distance below Z0.