Posts made by Carlos

undefined

cr8tor,

I ran into the same situation with my T3P3 Kossel XL for a couple weeks (2 issues resolved a week a part)

Pulley not tight enough (slipping)
Pulley not on correct position of shaft (too far in or out)

Once I corrected those build / mechanical issues, flawless with near consistent 0.017 std dev between calibration runs; no bed mesh compensation needed.

undefined

What kind of Authentication types will be allowed in the re-write?

WPA/WPA-2 (clear text passphrase, hex key, certificates)
WPS (send Gcode down to enable WPS for X seconds, press WPS button on home router to pair)

Something that would be nice (but probably out of scope)

mDNS advertising to find your Duet on the network
DHCP client options (lease options, hostname, etc…)

undefined

Hi Scott,

This is what I do with S3D to achieve what you are looking for.

For the first few layers I have one process that slows downs things a bit to ensure I get accurate infill/overlap on holes along with a solid bed adhesion. - https://www.simplify3d.com/support/print-quality-troubleshooting/#gaps-between-infill-and-outline

I then have another process which is essentially my "normal" print process.

You can check out S3D's Tutorial Videos here (https://www.simplify3d.com/support/videos/) which describe these features. In particular, this video: https://www.youtube.com/watch?v=EbQfifnzL4Q&index=9&list=PLogLRK5xzNdieu445p2O7wODJpQBVf-Ss