I've updated my config for RRF 3.x and updated it on GitHub - https://github.com/yincrash/Ender-5-Plus---Duet-2-Wifi-or-Ethernet-Configuration

Will happily take any input if people have better settings.

Sorry, I don't have notifications turned on. I'm finally upgrading to RRF 3.x, and will have an updated configuration once I have everything working again.

I stumbled on to this when upgrading an old Duet 2 Ethernet from v3.3 to the current 3.5.1. I set up my router to assign a specific IP address to the Duet based on the MAC address and had a slight freak out when the DWC couldn't reconnect to the Duet. Might be worth mentioning on the updating firmware page.

https://docs.duet3d.com/User_manual/RepRapFirmware/Updating_firmware

I've updated my config for RRF 3.x and updated it on GitHub - https://github.com/yincrash/Ender-5-Plus---Duet-2-Wifi-or-Ethernet-Configuration

Will happily take any input if people have better settings.

https://forum.duet3d.com/topic/20346/m117-is-spamming-the-web-interface/2?_=1637624356421

This topic indicated I just needed to also update Duet Web Control. Probably could use a little clarity in the upgrade doc for that.

Works great now

For anyone that finds this later, I just uploaded "DuetWebControl-SD.zip" from the release of the firmware that I had already installed, and it updated DWC.

See video - Continually shows printing notification or heating notification while heating or printing.

duet-printing.mp4

Sorry, I don't have notifications turned on. I'm finally upgrading to RRF 3.x, and will have an updated configuration once I have everything working again.

@Phaedrux said in Any full working Ender 5 Plus configurations?:

https://forum.duet3d.com/topic/14250/tuning-jerk-accel-speed-settings/2?_=1586651239957

Thanks

Additionally, has anyone tried making the existing touch screen panel work? I'm assuming it's the same touch screen in the CR-10S Pro, the model on the panel says "dmt48270c043_06wt". It seems to be a commodity panel, but I assume Creality put some sort of firmware on it for easy communication between the panel and the main board

I put my config up here -
https://github.com/yincrash/Ender-5-Plus---Duet-2-Wifi-or-Ethernet-Configuration

And made a tiny tester @ 0.24mm layers that has a bit of stringing with PLA, but otherwise reasonably solid. I may tweak my PrusaSlicer settings.

Tiny_Tester-e5.gcode

How can I determine what are my max speeds for my axes and are there any optimizations I forgot? I think I will also re-use the bed mesh saved to disk instead of constantly probing the bed every run. Also, when doing the top layer, the extruder skipped a bit. Not sure if that's from my slicer settings or the extruder rate in config.

I've been trying to edit a modified ender 5 configuration for the ender 5 plus and using the reprapfirmware configuration to generate config files. However the BLTouch settings generated by the configurator definitely needed editing afterwards. Also it defaults to homing Z with an end stop and not with the probe as well has homing x and y to 0 when it hits the endstops in the far right instead of front left as the origin.