@Phaedrux

Its working. It Was just the S1. After putting in. It works fine. Yeah rrf3.

@chop with s1 its enabled. Without anything ots disabled

@Phaedrux

Its working. It Was just the S1. After putting in. It works fine. Yeah rrf3.

@chop said in Duet RRF3 Filament Runout Sensor Pause:

@Phaedrux hey. Its a lerdge style frs.

Config.g

Endstops
M574 D0 S1 P"e0stop" ; configure active-high endstop for low end on C via pin E1stop

; Filament Runout
M591 D0 P1 C"e0_stop"

Maybe i have to write a "s1" into m591 command..... !?

@Phaedrux

Yes i have a Pause. G in sys
This is the sensor:

https://www.amazon.de/dp/B07FSXFPLD/ref=cm_sw_r_cp_apa_fabt1_PLxSFb14RC5MT?_encoding=UTF8&psc=1

I upload every print Codes on sdcard

@Phaedrux sensor Lights green when filament is loaded. Rf3 knows correct status (loaded or unloaded) but still no Pause

@Phaedrux

Thanks. I read this before. But its still not going into Pause if running out of filament.

Any Suggestionen?

@Phaedrux hey. Its a lerdge style frs.

Config.g

Endstops
M574 D0 S1 P"e0stop" ; configure active-high endstop for low end on C via pin E1stop

; Filament Runout
M591 D0 P1 C"e0_stop"

Hi. I got my FRS working bit if he is runing out of filament he keeps on printing.

How can i say them switch to Pause mode if u r running out of filament and how to test?

Best regards

@arhi ah !! Thats what im looking for. Thank you mate.

Would you pls show me your wipe. G. Thats exactley what im trying. Servo deploys brush nozzle Drives oder the brush to clean .

@Phaedrux

i try to explain

i want to add,heat to bed and hotend to X celsius(shpuld be print temp), do a makro, prob the bed, start the print.

the printer should do this one ervery print. where i have to add this commands?