Best posts made by crynool

Hi Chris,

I'd like to see i.e. the GCODE Console output always visible on screen, so I do not need to switch between the several sections back and forth again and again when experimenting.

Other than that, I'd like to have instead if a single line input for gcode some sort of 'copy and paste' multiple line edit window (again ... when experimenting...)

On top, some sort of customizing aspect when using pre-defined interactions, like 'Run Mesh ...'

I know, last points belong more into the 'feature request' section, but ...

Glad you sorted it out

As said, I made good experience with a paperclip. Flattened one end, put it between the connector and the housing, wiggled a bit, other side. Et Voila.

Keep in mind the config_override.g, so editing config.g might not show any difference