Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. Dani111
    3. Posts
    • Profile
    • Following 0
    • Followers 0
    • Topics 2
    • Posts 4
    • Best 0
    • Controversial 0
    • Groups 0

    Posts made by Dani111

    • RE: Circuit-design Peltier Element

      I forgot to mention, my peltier is TEC-40-33-127. I apply at the PWM input 3.3V and i think my circuit is not ok because the launchpad (MSP430FR4133) "scream".

      posted in Duet Hardware and wiring
      Dani111undefined
      Dani111
    • RE: Circuit-design Peltier Element

      I'm using this schematic, but it's not okay. I'm not sure which series of transistors to choose and i need help for that
      peeel.PNG

      posted in Duet Hardware and wiring
      Dani111undefined
      Dani111
    • Circuit-design Peltier Element

      Hi. I need a little help from experienced people.
      I want to control a Peltier element with a microcontroller,
      with PWM. May? The peltier element has the following parameters:
      Imax=8.5 A, Vmax=15.4V.Ok... I have a 12 volt source,17A for example.

      How can i design the circuit so that i can control the peltier element?

      A link to the peltier element data sheet is:
      https://eu.mouser.com/datasheet/2/433/Wakefield_Vette_Thermoelectric_Cooler_Full_Data_Sh-1501217.pdf

      posted in Duet Hardware and wiring peltier circuit-design help pwm control
      Dani111undefined
      Dani111
    • Peltier Element- Schematic Help H-bridge

      Hello,
      I need help to anyone who can help me 🙂

      A peltier can be reversed. So If I supply + to RED and - to BLACK
      it works as expected. But if I reverse the polarity, ( - to RED, + to BLACK), it will also reverse the cold and hot side.
      (To prevent the other side getting too hot, I have a heatsink on it with a fan blowing cool air over it.)
      I want to connect and control the element using MSP430 as launchpad(power supply: 3.3v) I use TEC-40-33-127.

      0_1566976311799_peltier.PNG

      I need to think about how to connect and control the 4 switches (4x IRF1405) to power the peltier in both ways, how to use the H-Bridge in both polarities.
      I need your help because I don't know how to make the circuit schematic I don't know what values to choose from resistors,
      capacitors and what kind of diodes to use, how to to maintain the current so as to the whole circuit should work .
      I attached below an exemple without H-bridge and I want something similar as in the schematic but for my element and with H-bridge.
      0_1566976594814_schematic1.png
      Thank you! 😄

      posted in Duet Hardware and wiring peltier h-bridge schematic electronic help
      Dani111undefined
      Dani111