@droftarts Here is what each color wire is for:
LED: Green Wire - 2 pin KK connector - PIN 2
HotEnd FAN: Purple Wire - 2 pin KK connector - PIN 2
LAYER FAN: Orange Wire - 2 pin KK connector - PIN 2
The additional black and red pair are for the Duet fan
Here is how the manufacture instructs us to connect the fans. Not being familar with the Duet I would guess that the wires are connected to the negative side of each fan connector.
I will check the fuses when I am off work.
@droftarts Thank you for the feedback. Let me clarify one thing. The image in my original post was how I received the machine/board setup. I since set the printer up as per the manufacturer (see included images).
I am fine having the hotend fan on all the time as all of my other printers are like that as well. I just need to figure out the layer fan. Are the fuses something easily changed?
.
I recently picked up a V3.2 off eBay and after replacing the whip and hotend with brand new ones from SeeMeCMC and installing per the setup guide, none of my fans work (not the hotend fan nor the part cooling fan). I tried heating the hotend to temp and the hotend fan still did not come on.
When I place the hotend fan wire to a different port, it comes on just fine; however, nothing I do will turn the part cooling fan on.
Attached is a picture of how the original owner wired the part and hotend fans (orange an purple wires) as well as my current config.g file!
I am running stock firmware from SeeMeCNC as the V3.2 came with nothing loaded on the SD Card (so any setting change made to get it to work were lost).
Here is the output from the M115 command:
10:43:40 AMM115
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.02(RTOS) ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2018-12-24b1
I am new to Duet boards so any assistance is appreciated. I am hoping it is not the board itself that needs to be replaced.
