@phaedrux I guess I'm giving up. I was hoping someone would share their solution, but I guess it's too much to ask. I'm returning the duet2 wifi, 4.3" paneldue, duex5, and thermocouple boards to Amazon, and I'll just go back to the stock board and flash it with Klipper. Thanks for the help.

@phaedrux That is an older BLTouch. The newer ones have a QR code on the bottom. Mine is v3.1, and is a bit different. I believe the +5v and GND are swapped, and it can also do +3.3v logic automatically, without needing modifications.

The breakout board seems new to the latest versions of the Ender 6, as my breakout board has a date of 3/31/21. I'm still mapping out the connections to the breakout board and the different connections coming out of it, and I'll post what I find, and if I work it out, what the solution is, as nobody seems to want to share what they ended up doing.

Edited: I will upload photos, and re-do my wiring diagram, because it was wrong.

@phaedrux I believe many things in the upper portion, like X and Y endstops, extruder, extruder fan, parts cooling fan, filament runout detector, and BLTouch that have one, all share a common ground.

looks like the BLTouch's yellow and power are tied into the two pwm wires. The yellow, black, and blue wires on the BLTouch are all grounded conductors, but I'm assuming the blue maybe a tx/rx. The filament runout has a power, ground, and a yellow wire, that is also a grounded conductor.

I hope you can help me. Thanks a lot, either way.

@phaedrux that was meant for @javcab

Sorry

The "det" one is a 4-wire, which I believe is where the BLTouch, and whatever else is on the breakout board, gets its power from.

The "pwm" wire is a 2-wire, with what looks like a neutral and a 2nd wire.

I can use a meter to see where they actually go, but I'm not sure about where on the Duet they would go. There is literally no information online regarding this.

@phaedrux Would you mind sharing how you wired the "det" and "pwm" wires from the Ender 6 to the Duet board?