@phaedrux
Uploding the bin file do not solve the problem.
the m997 command : start the update again.
See the message:

I will try the bosa procedure later.

thank you.

Denis

@phaedrux
Uploding the bin file do not solve the problem.
the m997 command : start the update again.
See the message:

I will try the bosa procedure later.

thank you.

Denis

@chrishamm

hello, with the m997 command it do an update but in dwc it is not updated.
see screen shot.

any other way to resolve this?

tank you.

Denis

@phaedrux

Hello, that's exactly what I did.
I think the board update is done but it doesn't show it.
is there another way to solve this?

Denis.

I have update my duet 2 wifi. now i see in the general section: Duet Web Control 3.4.2.
but in the section machine specific: i see this: Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.3 (2021-06-15)
it still on the ver 3.3 and not 3.4.2! how can i update this?

thank you.

Denis

@RichardDuke
hello, great achievement. do you have a site where we can download the stl?

I just checked again it's an image every 5 sec

it seems to work. but it captures an image every 15 or 20 sec. it is not possible to have the video stream? is there a doc on the config of the camera in v 3.2?

@hmortensen
no, i will try tonight

@Phaedrux
Hello, i use a duet 2 wifi with rrf 3.2 en dwc 3.2.0
I put the following in the camera config: http://192.168.1.27.
with this url in a browser it work but no in dwc.

Denis.

hello, how to make an ip camera work under dwc v3? what url should he use. my ip camera is a esp32-cam.