Topics created by Electra

The expansion connectors use different pinouts, so you could not use a straight through 50-way cable. But if you got the wiring right then it should work.

I found the problem 🙂
I've used "M570 S999" command in config.sys, but this command is only valid for ver 1.14 or earlier.
The first attempts the printer was stopped because the heater temperature drops more than 10 C.
Later attempts failed, with increased M570 P and T parameters, because the printer time out after 999 seconds (with unspecified heater…:-O ).
The strange thing now is the heater temperature are stable close to 250 C when I'm printer ABS.... but I don't care to found the main reason or faults behind the earlier temperate drops, because the printer works perfect now 🙂
Thanks DC42 !

@Kulitorum:

Rmpfh….

Still does not compile, and I have no idea what _sbrk is:

22:45:17 **** Incremental Build of configuration DuetWiFi for project RepRapFirmware ****
make all
'Building target: DuetWiFiFirmware.elf'
'Invoking: Cross G++ Linker'
arm-none-eabi-gcc -L"C:\Eclipse\ReprapFirmware\CoreNG\SAM3X8E" -Os -Wl,--gc-sections -Wl,--fatal-warnings -mcpu=cortex-m4 ...

Your library path is wrong. For the Duet WiFi build of RRF, you should be using the SAM4E build of CoreNG, not the SAM3X8E one.