@bearer I was just trying to point out that is something needed for some scenario, in any way, even if we are in our own private network. There is no need to "reinvent the wheel".
Best posts made by ernstc
Latest posts made by ernstc
RE: Mesh grid (557) restored to old value after homing Z
@dc42 Yes, I have. Thanks!
So, the solution is to change the grid and then execute the mesh bed probing, so that the height map file is updated.
DC42 IR Probe analogic mode on Duet3?
My previous board was a Duet2 Wifi and there the IR probe was configured to work in analogic mode. Infact at startup it used to flash 4 times.
With Duet3 board the documentation says that the DC42 IR probe must be configured with mode 8, that is digital. Now at startup the probe flashes 2 times indicating the digital mode.
Why it does not work anymore in digital mode on Duet3? Or am I missing something?
Mesh grid (557) restored to old value after homing Z
My configuration is Duet3 + Raspberry + RRF 3.0 (2020-01-03b3).
In the beginning my mesh grid settings were:
M557 X38:268 Y61:254 S40.0:40.0
I changed the mesh grid in config.g as below:
M557 X38:268 Y61:254 S80.0:80.0
The problem is that when I home Z, the mesh grid is restored to the old values with spacing 40.0 instead of 80.0. I can't find any *.g file with an M557 command.
Where are stored configuration files in the SD of the Rasperry? Can't find them either navigating in the file system.