I still have a PI3 running Octoprint with camera. I do this for the camera and some Octoprint plugins I like for LED and heater control of my enclosure. Works fine.
Best posts made by Flyer007
Latest posts made by Flyer007
RE: Current options to integrate a web cam (similar to OctoPrint)
RE: Control non ATX power by PS_ON output
Wired like you have it strips and it works great!
RE: Notification via Pushover or other service
Nice work on the Push; But I agree the API would be sweet and open up a bunch of capability.
Personally, rather than support for a single notification service, I'd rather see an API for pulling data from DWC. So we could poll the data its already displaying without generating more gcode for the duet itself to worry about. (Temps, file progress, etc)
Then it'd be trivial to use a PI or similar to do stuff with that data - push notifications, light up LEDs, turn on/off a webcam, whatever by reacting to data pulled from the API.
(If such an API already exists, I haven't found it referenced yet)
RE: Adifruit addressable led support
Might be better to just offer triggers to another board. Which is then tasked with the LED control. Addressable LEDs can use a lot of resources.
I would like this since I run a Pi3 with camera on it to serve the Duet Wifi, video. I am also setting it up for the LEDs, enclosure heater and filament dryer controls.
RE: Should I wait for the DC42's PCB carriages or go Robotdigg?
Steppers are not defined 12v or 24v so good to go in both.
RE: PS_on switching a SSR
What about mechanical relay like this one? https://www.amazon.com/gp/product/B00E0NTPP4/ref=oh_aui_detailpage_o06_s00?ie=UTF8&psc=1