Topics created by foehnsturm

Docking positions are fixed, the upper part of all tools features the same docking geometry. But the position of the tool tip may vary from tool to tool. The offsets are defined with G10. However the docking and undocking procedure is completely independent from theses offsets.

But isn't this only for Z?
I'd like to probe for the X and Y offsets as well.

Yes, you can use the.M563 command to create several tools that use different heaters but the same extruder drive.

Hi guys,
Thanks for the fast reponse.

Videos about the Ultimaker toolchanger project can be found here: https://www.youtube.com/playlist?list=PLeNzDYMnqAqIeZHWU9iOWnj_2OaemupQG