Boy do I feel STUPID!!!! I was doing some calibrations last week (new filament) and forgot that I can't adjust x an y steps like in a cartesian printer. Went back and used same steps for both motors and now all is fine. It's amazing what pops into your head when it's 3 in the morning and you can't sleep!
Best posts made by GeorgeM
-
RE: Could Duet2 cause this? CoreXY skew.posted in General Discussion
-
RE: Duet Wifi and BLTouch v3posted in Duet Hardware and wiring
I am new to the Duet but have had the BLTouch v3 working for the last 3 weeks or so. There was no extra steps to do . Just plug directly to the pins described.
-
RE: Is the PanelDue display my only option?posted in General Discussion
Thanks @jay_s_uk . That was it. I had just plugged in the cable as it was without tracing the lines. Working now.
-
RE: Solved-First time setup. Cant get steppers working properlyposted in Duet Hardware and wiring
Thanks bricor
It actually was wired correctly. What I found is that when I was switching X and Y one of the pins for Y had pulled loose. Once I reconnected that I was able to get them operating correctly.
This is my first post here. How do I edit the title to show it is solved? -
RE: My BL Touch not self testing or deployingposted in Duet Hardware and wiring
If you go here https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe
and go down to the BLTouch section, that wiring will work with V3 of the BLTouch.
I have it working great with independent Z motors and mesh grid