yes i have one done for the heater and the bed.
Warning: heater behaviour was not consistent during tuning
Auto tuning heater 0 completed after 4 idle and 25 tuning cycles in 5317 seconds. This heater needs the following M307 command:
M307 H0 B0 R0.957 C113.0 D6.66 S1.00 V24.2
Edit the M307 H0 command in config.g to match this. Omit the V parameter if the heater is not powered from VIN.
M307 H1 B0 R2.746 C97.9:59.2 D5.41 S1.00 V24.2
after firmwareupdate now it takes very long to heat up the bed. is this normal?