@jay_s_uk said in Checking Trigger Status:
@Glen_Remix post an output of
M98 P"config.g"
and I see the .iso thing is specific to the 6XD. thats my new thing learnt today
M98 P"config.g"
HTTP is enabled on port 80
FTP is disabled
TELNET is disabled
Hi all,
I'm working on a project using a Duet3 6XD for motion control for a larger system controlled by a PLC.
The PLC has 5 24V PNP outputs which trigger macros on the Duet, and 2 inputs from the Duet to indicate 'Busy' and 'Finished' states.
I have used up all four opto-isolated IO, and need to use three other pins.
The datasheet states that the Input pins are +30V tolerant. Does this mean that I can connect the IO GND pin to the PLC 0V and the ioX.in pin to the PLC Output? Does this require anything else to avoid damaging the Duet?
The PLC output is up to 0.5A per channel.
Any advice would be greatly appreciated.
Thanks,
Glen
@jay_s_uk Thanks for your speedy reply!
Looks like I'll have to do some rearranging to reach that port.
Thanks!