Posts made by hanzn44

@makerdise I send a PN to you. Thank you.

I try to contact my reseller for the warranty replacement a few times. But there is no reaction from makerdise.com. Any other possibility?

@dc42 Thanks for your answer. I haven't understand everything now. But it`s only when I try to home the Z-axis.

@Phaedrux The Board was bought in Dezember. I think I had it installed in the End of March. So it's new and not older than 6 months now.

Thank you for tip. But I really triple checked all cable with elect. measurement as I installed the board. Because I`ve never payed so much for a board so I was really carefully. Never made this work before for other boards.

It was planned to use a second extruder, but if there no other way any more I have to use the E0 as Z.

Thank you so much.

@hanzn44 said in Error: over Temperature shutdown reported:

config.g

Z.Axis is for example like a tronxy x5.

Was it hot?
I could touch the driver and it didn`t feel hot. But i thought there was a little burnt smell.

I tested it with a stepper from another printer which definitely working, and he do nothing on the duet

The wire were crimped with the duet included plugs.

Sorry for my bad English.

And after the first problems I dismantle the stepper from the Axis. so it's not a mechanical problem.

config.g

Z.Axis is for example like a tronxy x5.

Was it hot?
I could touch the driver and it didn`t feel hot. But i thought there was a little burnt smell.

I tested it with a stepper from another printer which definitely working, and he do nothing on the duet

The wire were crimped with the duet included plugs.

Sorry for my bad English.

Hello
My Printer worked very well over hours. But today I want to Home my Z Axis and got this Warning
Again and again. Checked all cables, tried other stepper motors.

Whats wrong. Is it broken?

Thanks.