Posts made by hnwhite

I use a Pei sheet from Gizmo Dorks on amazon on both of my Ender 3 pros, along with a glass bed. When i applied mine you peal back the adhesive and apply roll out as much air as possible. Then heat the bed to 80-90C applying constant even pressure. Ive never had an issue with it coming up like that, Tough that may be because of my glass bed. good luck to you!

@T3P3TONY e3d says I need an admin to comment on this post.

@roland thank you, so much I don't understand why they made me post on here for an obvious hardware issue. I filed out the form, what is the process from here?

@elmoret bought it from e3d was basically told to post here... Basically been given the run around... EXTREMELY upsetting from e3d..

Has anyone else had this issue? My paneldue 7i came with sg1 on the front of the board riped off and the erase button riped off. Plus the ribbon cable riped.!!! The screen is also really off center 0_1558382462298_1558382450194378265630858607733.jpg 0_1558382476103_15583824643091254208996795755752.jpg