Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. incurio
    3. Best
    • Profile
    • Following 0
    • Followers 0
    • Topics 4
    • Posts 21
    • Best 3
    • Controversial 0
    • Groups 0

    Best posts made by incurio

    • Part Cooling Fan not working on P6 and P8

      I am running an e3d toolchanger , Core XY printer with 4 tools. Running latest version of RRF2

      The Fan on P6 has not been working for a while now, so after unplugging the board and rewiring it again , I am now no longer getting fan p8 to turn on as well,.

      What I am seeing -- when I plug and measure the current from P6 and P8 it is reading in the 23-24V range all the time, even if the tools are not active.

      The 2 cooling Fans in P2 and P4 have a Voltage of 0 when not running and ramp up as I slide the fan from the web UI.

      I applied a 24v charge to the 2 cooling fans on tools 3 and 4 (P6,P8) and they were spinning ok.

      It is when I decided to measure the tools with working fans that I noticed that those had an initial voltage of 0 when powered off and not constant like the other 2.

      All the thermostatic fans 1,3,5 and 7 are working fine. When I turn on the hotend the hotend fan will fire up as expected without fail.

      Run out of ideas on what else to check -- hoping it may just be a config setting that I may have overlooked.

      thx:

      posted in Duet Hardware and wiring
      incurioundefined
      incurio
    • RE: Part Cooling Fan not working on P6 and P8

      @incurio unable to post m122 command or config.g file -- being marked as spam.

      posted in Duet Hardware and wiring
      incurioundefined
      incurio
    • RE: Part Cooling Fan not working on P6 and P8

      @incurio Using a Duet2 WIFI with Duex5 expansion board v0.10

      posted in Duet Hardware and wiring
      incurioundefined
      incurio