thx,
when printing is finished, I will check
Measure each time after changing the tool. And forget about the matter (don't think if I have a T1 or T2 tool on the machine).
I'd rather take a measurement every time.
I have a good and rigid connection between the stroller and the headstock. But not always the same amount.
In which file and what to change? I'm not proficient in duet3d.
Home switch i have on top.
After each reset, i go on home switch. On the end of config.g I have 'G28'.
I understand. As I wrote, I rarely change my head. I would like to measure immediately after the change and no more.
Switches measure the height of the Z working field.
I have heads with different nozzle lengths. I change them depending on the material I'm working on.
@BoA
no. It doesn't even save.
If I turn it off and on after a measurement, I have to do it again even though I haven't turned on any gcode.
My switch is 24mm high.
I want to take only one measurement.
I change the head (height) every few prints.
I have a switch of this kind:
Now everything works, the only problem is that it doesn't remember and I have to take a measurement before every print.
Takes the measurement. Then it goes up and does not stop at the limit switches. He tries to keep going.
M558 I1 T6000 F1200 P3 H300;
G28;
G31 Z24;
P31
G30
Will it be good?
Sorry, it's printing now and I can't check it.
My probe script
M558 I1 T6000 F1200 P3 H300;
G28;
G31 Z24;
G30;
When I did it, no change in config-override.
I have a problem. The 3d duo does not remember the measurement. I have to do it, every time before printing.
tfree1.g tpre1.g sleep.g stop.g tpost1.g pause.g resume.g homedelta.g config-override.g bed.g dwc.json config.json config.g