Great, thank you!
Latest posts made by jan19
Offset for Dual Y Endstop?
I have just been converting a CNC router to a duet 2 ethernet board.
Everything seems to work fine.
I am running two seperate steppers on Y with an endstop each.
Using marlin I used to be able to square off the axis perfectly by setting up an offset for the endstops using the M666 command.
Is there a way to do something similar on the duet 2?
Firmware is 3.11
RE: G29 in start code and probing errors
I have a piezo sensor.
So if that happens, there is usually a physical problem.
Like a tiny bit of oozing filament on the nozzle I forgot to clean away or something on the printbed.
So only solution at this point would be to probe manually and remove the g29 from the startcode?
G29 in start code and probing errors
I have "G29 S0" in my start code to probe the bed every print.
The problem is, if I have an error during probing, like "Error: Z probe already triggered before probing move started" or not consistent probes, the print still goes on.
Obviously this is not what I want.
So where is my error in thinking there and how do I set it up, so that the print stops/cancels if an error occurs?