Topics created by jevs

@jevs said in MAC Address issues:

Adding that entering "M540" by itself will report the MAC address would be great since it does work.

This is true of any gcode that is used to set values. Sending it without values will return the currently set values. I'll add a note about that to the gcode wiki though.

I had a range extender put between the modem and printer (it's on opposite sides of the house) It was fine up until yesterday, it would connect, but disconnect when attempting to upload. I removed the extender and boom! everything is peachy.

Also make sure you reserve the 2.4 band for the printer if you can, and run all else on 5.8.