@dc42 , I've not opened up the side panel yet to look. What are the four out ports for? There are two x-y steppers, one hot-end extruder, there are then two fans, one exhaust the other is the hot end cooling fan. That's 5. I'm new at this.
Posts made by jfhunt
-
RE: Duet custom board on Fusion3 F410posted in Duet Hardware and wiring
-
Duet custom board on Fusion3 F410posted in Duet Hardware and wiring
Does anyone know if the custom board that was built for the Fusion3 F410 has any extra control pins that might be able to control a 12v or 24v switch or relay activated by gcode? It would be similar to what is used in many smaller tabletop laser or cnc's where a solenoid is opened to start air flow for the laser or other device.
Any thoughts?