@t3p3tony That got it working, thank you

@dc42 I tried moving it around a bit, but to no effect. Even though I put 1.20 and later in the configuration settings, config.g still says 1.17-1.19. Could this have something to do with my issues?

@mrehorstdmd Thank you, although switching out the pt100s doesn't even temporarily fix the problem for me, so I'm sure i'm having another issue. Will definitely look into the E3D sensors though.

@mrehorstdmd i believe so

@mrehorstdmd Not sure where my boss got the sensors, but I've tried to switch out a couple of them, so i'm pretty sure it's either a wiring or configuration issue. I ordered a new daughterboard because that seems like the most likely fix. For now i have got it working with regular thermistors though.

@dc42 It says movement before homing is not permitted. All of the firmware is updated to 1.21 except for the paneldue, could that be the problem?

@dc42 I added it here, but I'm still getting the same result.

@dc42 I updated all of my firmware to 1.21 and this successfully switched the setting from x-axis to z-axis. Only thing is that I now get this error when trying to manually probe the z-axis.

@T3P3Tony, @dc42 , We have figured out the Heaters Fault configuration. We are now having issues configuring the Z-axis. Any suggestions as to why the manual Z-Bed Probing is asking us to adjust the X-Axis?

@phaedrux I only have a two-wire pt100 sensor. Both sensors are wired the same exact way, however one of them works while the other is completely dysfunctional.