@Phaedrux Wow, thank you! I will send an email.

ordered plunger minihooks. Should suffice.

@bearer said in VSSA fuse?:

1A automotive fuse over by the Vin connector.

Where is it?

Also, my caregiver could not get a steady VSSA reading... any tricks of the trade? alligator clips fall off...

Thank you...I will take a look when I can and get pictures. Quad life... might be awhile.

I am pretty sure that I blew the VSSA fuse on the Duet 3D Wi-Fi v2. I was trying to upgrade a old Flsun i3 (really old Cartesian printer). I tried using the configuration tool, and all the motors were working fine.
Turned my attention to fans and heaters, and wired everything. I wasn't really sure about configuration so I added the extruder as a tool. I heard a pop and smelled some smoke and now both the heater and extruder temperature show 2000°. In addition, the fans no longer work.
From reading the discussions, it sounds like the VSSA fuse might be the problem. I don't think I'm capable of soldering (I am a quadriplegic). Of course, I plan on checking the resistance across the fuse, but is there anything I can do without soldering? I would like to get the extruder and fans to work, maybe the heated bed. Were there some minimum requirements for the thermistor, fan, or heating bed? I just plugged them in according to the diagram under "getting started."
At this point, I think my caregivers would prefer I just buy a new assembled printer.

I will take any advice.