Well that's the easy solution... 
Seriously did not think about that. Thanks!
But I'm still curious if there is a way to do it in firmware.
Posts made by JMT_3D
-
RE: Check Filament before printingposted in Duet Hardware and wiring
-
Check Filament before printingposted in Duet Hardware and wiring
Hey,
I was wondering if it's possible for the DuetWifi to check the currently loaded Filament before starting a print job, as it has happened, that the wrong filament was loaded. This happens especially when having multiple gcode files for different filaments on the SD-card.
Surely the slicer would need to put the information about what filament to use into the gcode.Is there any functionality like this in the RepRap firmware already?
Thanks,
Matthias, JMT3D