@Phaedrux said in error: G0/G1: insufficient axes homed:
config.g
I Tried what you asked this is what i got
HTTP is enabled on port 80<LF>FTP is disabled<LF>TELNET is disabled<LF>Warning: M308 command is not supported<LF>Warning: M950 command is not supported<LF>Warning: M308 command is not supported<LF>Warning: M950 command is not supported<LF>Warning: M950 command is not supported<LF>Warning: M950 command is not supported<LF><LF>Done!<LF>RepRapFirmware fo
M122
=== Diagnostics ===<LF>RepRapFirmware for Duet 2 WiFi/Ethernet version 2.0(RTOS) running on Duet WiFi 1.02 or later<LF>Board ID: 08DJM-9178L-L4MSN-6JKDA-3S46L-TS1LP<LF>Used output buffers: 1 of 20 (9 max)<LF>=== RTOS ===<LF>Static ram: 28380<LF>Dynamic ram: 95672 of which 0 recycled<LF>Exception stack ram used: 268<LF>Never used ram: 6752<LF>Task NETWORK ready, free stack 324<LF>Task HEAT blocked, free stack 1264<LF>Task MAIN running, free stack 3656<LF>=== Platform ===<LF>Last reset 00:01:16 ago, cause: power up<LF>Last software reset time unknown, reason: User, spinning module GCodes, available RAM 6796 bytes (slot 3)<LF>Software reset code 0x0003 HFSR 0x00000000, CFSR 0x00000000, ICSR 0x0440f000, BFAR 0xe000ed38, SP 0xffffffff<LF>Error status: 0<LF>Free file entries: 10<LF>SD card 0 detected, interface speed: 20.0MBytes/sec<LF>SD card longest block write time: 0.0ms<LF>MCU temperature: min 24.1, current 27.3, max 27.4<LF>Supply voltage: min 1.1, current 1.7, max 1.7, under voltage events: 0, over voltage events: 0<LF>Driver 0: ok, SG min/max not av[Warning: Maximal number of bytes per line exceeded! Check the EOL (end-of-line) settings or increase the limit in the advanced terminal settings.]
M122
M98 P"config.g
HTTP is enabled on port 80<LF>FTP is disabled<LF>TELNET is disabled<LF>M308 command is not supported<LF>M950 command is not supported<LF>M308 command is not supported<LF>M950 command is not supported<LF>M950 command is not supported<LF>M950 command is not supported<LF>ok<LF>