Best posts made by Kane

Sorry for my self talk but I solved my problem. To run am mix of 5V and 24V fans i used the following solution.

• Set the "V FAN" jumper to the V_FAN;VIN position
• Connect the 24V fans normaly
• Connect the black alias ground wire to the minus pin of the chosen fan port
  !Do not connect the red alias puls wire to the fan port, with great probability you will destroy our fan and/or the board
• Connect the red wire instead to the free 5V pin of the before described "V FAN" pinout area

Now you are able to control all fans from full power to switch off

Maybe a mod can take my description and put it into the wiki, maybe its more easy to find there

Thread closed

Sorry for my stupid post above, ist much easier than that. Fortunately my axis to adjust was y. So here my code from my homeall.g

G91             	                ; relative positioning
G1 H1 Z200 F1200 	; move quickly to Z axis endstop and stop there (first pass)
G1 Z-3 F150      	        ; go back a few mm
G1 H1 Z200 F100       	; move slowly to X axis endstop once more (second pass)

G1 H1 X-698 Y-355 F3000     ; move quickly to X and Y axis endstops and stop there (first pass)
G1 H2 X5 Y5 F6000                ; go back a few mm
G1 H1 X-698 Y-355 F360       ; move slowly to X and Y axis endstops once more (second pass)

M584 Y1 U3 P4        ;split y axis 
G1 Y1.2 F100           ; drive y axis (drive 1) 1.2mm back
M584 Y1:3 P3          ;recombine drive 1 and 3 to y axis 

G90                     ; absolute positioning