Hello!
I'm trying to configure Mosquito Magnum Dual Heater on Duet 3 6HC + Toolboard 1LC.
When I configured two heaters for one tool as below, it works ok.
M308 S1 P"21.temp0" Y"pt1000" A"Right A" ; configure sensor 0 as thermistor on tool board board pin temp0
M308 S9 P"21.temp1" Y"pt1000" A"Right B" ; configure sensor 0 as thermistor on tool board board pin temp0
M950 H1 C"21.out0" T1 ; create nozzle heater output on out0 and map it to sensor 0
M950 H9 C"21.out1" T9
M307 H1 R1.085 K0.153:0.000 D4.55 E1.35 S1.00 B0 V23.1 ; PID parameters - tuning separetly
M307 H9 R1.085 K0.153:0.000 D4.55 E1.35 S1.00 B0 V23.1 ; PID parameters - tuning separetly
M143 H1 S455 ; set temperature limit for heater 1 to 455C
M143 H9 S455 ; set temperature limit for heater 9 to 455C
M950 F1 C"!1.out8" Q10000 ; configure fan 0, F = 10 kHz, PWM range from 0.3 to 1.0
M106 P1 S0
M563 P1 D1 H1:9 F1 ; define tool 1
G10 P1 X0 Y0 Z0 ; set tool 1 axis offsets
G10 P1 R0 S0 ; set initial tool 1 active and standby temperatures to 0C
But unfortunately it's impossible to tuning it correctly. I can't tuning two heater at the same time. So I want to use two outputs for one heater as below:
M950 H1 C"21.out0+out1" T1
This line is copied from G-codes dictionary M950 examples, but returns error:
7.11.2022, 10:32:53 Error: M950: Unknown pin name 'out0+out1'
I tried:
M950 H1 C"21.out0+21.out1" T1
But result is the same.
What is correct g code syntax to define it?