Hello everyone,
I installed a laser to my 3D-Printer and I wan't to use Lightburn Software to control it. It is working, but not perfectly. Depending on wich controller I pick in the setup of Lightburn, I can get images or lines working correctly, but not both. I've read, that you can get it to work flawlessly without postprocessing. Can anyone confirm this?
What a possible way to get everything working as intended?
Best regards and thanks in advance,
Leo
Thanks a lot! You are awesome!
Hello,
I'm currently building an 3D-Printer with a toolchanger.
Tool 1 has an offset of roughly 10mm in both X and Y. When I want drive into the parking position I obviously have to use coordinates that compensate for the ~10mm offsets.
This works well until I have to do some maintainence on the tool. Lets say I screwed it in 1mm differently. After recalibrating the tool offsets I will get a crash when parking.
Therefore it would be usefull for me, if I could ignore the tool offsets during all parking moves and just use the carriage/global coordinates. Is this possible?
If not, is there a workaround? I tried two methods:
1.) Using T0 at the first line in tpre1.g and tfree1.g: This creates an infinite loop (as expected)
2.) Resetting the tooloffsets to 0,0,0 in the first line in tpre1.g and tfree1.g and setting it to the correct value in the last line of tpre1.g. This completely freezes the interface.
Best regards,
Leo
Ps: I'm running RRF3
Thanks a lot! I'm up and running wir RRF3 now 
Thanks to both of you. I'm currently using RRF 2. I thought it might be smarter to stick with a version thats been around for longer to I find answers to my problems more easily. Should I upgrade?
By defining the extruders specifically, you 'undefine' the remaining axes. The only problem with this is if you're using a PanelDue, which sort of ignores the definitions, and shows all the heaters/extruders up to the last defined one.
I am using a PanelDue. 
Does anyone know if this is improved in RRF3?
Hello!
I'm currently building a new printer with a Duet2 Wifi and a Duex5. I'm planning on using up to four hotends.
My wire layout would be the cleanest, if I only plug my hotend heater cartriges in the Duex. The default is extruder 0 and 1 on the Duet and exturder 2 and 3 on the duex. How do I change that? I found a thread that kind of exlains how to do it for the heatbed ("Remap heater channel / pin."). But I wan't to do it with the hotend heaters.
Best regards and thanks in advance,
Leo