Topics created by LucasCarreno

You probably have Cura set to absolute extrusion and your end gcode has a retraction in relative extrusion which is causing the extruder to move to a very early absolute position.

The solution is to either add a switch to relative extrusion mode before your retraction in your end gcode, or better yet, switch Cura to use relative extrusion. Search the settings bar.

M566 X12000.00 Y12000.00 Z12000.00 E1200.00 ; set maximum instantaneous speed changes (mm/min) M203 X12000.00 Y12000.00 Z12000.00 E1200.00 ; set maximum speeds (mm/min) M201 X3000.00 Y3000.00 Z3000.00 E10000.00 ; set accelerations (mm/s^2)

These values are far too aggressive. Try these instead.

M566 X1000 Y1000 Z120 E1200 ; set maximum instantaneous speed changes (mm/min) M203 X12000 Y12000 Z600 E3000 ; set maximum speeds (mm/min) M201 X1000 Y1000 Z60 E3000 ; set accelerations (mm/s^2)