Topics created by Machoo566

@bot said in Need Help with large scale printers tuning!:

...................... I am only assuming full step microstep resolution is a thing, anything else is just for quietness and smoothness.

That seems perfectly reasonable to me. I keep toying with the idea of doing the gearing thing with "remote" motors - one day I'll find the time........

I may have been slightly premature with the course and fine as one picture is much closer zoom - it was late at night! 😄

That said measure from high point to high point from one wave to the other (wavelength) of the vertical pattern on the fin. Measure along one layer and try to pick the pattern that isn't a ghost of the edge of the part.

The latter is likely to be the Jerk is too high, but could also be a loose belt. I've found if the four pillars of the the benchy part (search benchy3D if you're not sure what I mean) are looking very poor that can often be a sight of low tension on the belts.

I'm going through this sequence at the moment with my machines!