Solved!
This is what I have done:
- I updated the firmware to version 3.4.6
- I grounded the hot-end with a wire to the ground of the power supply.
Side note:
During the last week when I was having the problem of the printer stopping midprint and resetting , I put on the heating in the printerroom.
The temperature was a convenient 23 degrees Celsius and the humidity had dropped to 45%,and that's low.
I can imagine that the low humidity has a negative effect on the buildup of static electricity causing the printer to stop and reset.
I'm not sure but I can imagine.....
@jay_s_uk : Thanks again and enjoy you're weekend.
Best regards,
Marc