Topics created by mct82

@mct82 said in Duet3 1LC resets during print job - does not pause:

@dc42 So I made no changes to the wiring, but commented the M591’s out of the config and restarted. I was able to complete a 36hr build w/o interruption.

With that knowledge I will double check the wiring to the MFM. I’m wondering if a “sensor error” on the MFM could be causing a reset on the 1LC? Or maybe a wiring problem is causing both the sensor error and/or the 1LC resets.

If a software error caused the 1LC to reset, then the "Last reset reason" would show as "Software", not "Power up".

Closing this due to lack of response.

The heater faults appear to have been resolved by switching back to known-good PT1000 sensors. I guess I will look into wtf is going on with these new RTDs.

Since the failure-to-pause issue is already a known issue, I'll mark this as resolved. Thanks