Thank you for that reference.
I did go through the forums before I posted here, and I found several posts, including a few linking to the Arduino -> RepRap transition. The core problem is that the manufacturer will not share anything about the F430's settings. None of the posts documented what folks learned during the transition. I was hoping to learn where the pitfalls are before I do something which fries the unit.
Hi All,
I have a CreatBot F430 which is giving me a lot of problems with poor print quality. And obviously, I wont be getting any firmware help from the manufacturer. Can folks who have performed a transition to Duet offer some help to get the transformation process started. Maybe there are settings folks have discovered which can be documented publicly for future reference?
I haven't worked with 3d printer firmware before, but I think I am savvy enough to follow steps if you guys could point me in the right direction, and maybe share what you have learned while doing this for your units?
Thanks!
Merlin.