How would you wire a BL Touch to a Duet Wifi if the expansion slot is already ocuppied with a Duex5.

@dc42 OK, thankyou, i purchased the board through E3D so will i need to contact them instead, or can i go through you on this occassion

@dc42 Hi There
Heres the photo of the blown chip.

@fcwilt Hi There
Here are the photos, hopefully you will be able to see if ive wired it wrong, but i think everything is correct. The board is also on 10mmplastic standoff son that nothing can short out the underneath.

@dc42 Yes not a problem, ill send over some photos this afternoon after i finish work, Thankyou

Thats the frustrating thing I did double/triple check the wiring, this is the problem, i cant see where i went wrong, everything looked correct

I cant see the component number for the chip, but its very close to U3, if that helps

No sure, theres not much of it left, Its small square chip close to the fan inputs and the jumpers infront of them.

Hi There,
Not sure if anyone can help, but just purchased my New Duet Wifi. Ive set it up via my computer, all working fine. Installed it on my E3D Bigbox. Turned it back on, and the board went bang and a chip on the board caught fire. As excepted the board now doesnt work and if i plug it back into the computer it doesnt see it and comes up with an USB error. The PanelDue also doesnt come on as well when plugged into the Duet, and works fine via the micro USB but doesnt connect.
Please Help