Thanks, now with junk code removed everythings works as it should.
Now I can start with the part 4 of this guide https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40
Thanks, now with junk code removed everythings works as it should.
Now I can start with the part 4 of this guide https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40
Thanks, now with junk code removed everythings works as it should.
Now I can start with the part 4 of this guide https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+4:+Calibration/40
Ok, therefore it is preferable to use the probe to home Z axis, but I don't understand why when I home to Z max the system thinks that Z max is 199 and not 235 that is the value that I have used in M208. Do you have any idea?
@Phaedrux said in Problem with bed leveling and U axis:
You don't need to provide dual values for the Z axis in all of those places. The settings are configured per axis, rather than per motor.
Z60.00:60.00 should just be Z60.
Extruders are the only axis that must be defined individually.
Thanks, I will remove this junk this evening
If I home first only Z-axis and then home all axes, there's no problem with Z coordinates, but if instead I do the opposite, in the dashboard the Z-axis, that is homed to its max, is equal to 199 and not 235 that is the value that I have in config.g.
Here my bed.g
bed.g
Now bed leveling works, but why when I home only Z-axis in the dashboard Z=199 even if I have set max Z-axix to 235?
Hi, I have updated my Ender 3 with a Duet WiFi, bltouch and a dual stepper motor system for the Z axis with two end-stops at high position. Now I'm the "setup phase" and I have some problem with bed leveling. When I launch G32 I have this error "Some computed corrections exceed configured limit of 1.00mm: 1.402 -37.558". If I'm not wrong it means that at left leadscrew it probe 1.402mm and at right leadscrew 37.558mm, but this difference is impossible.
I think that the problem is in the position of the U axis, in fact when I launch "M584 Z2 U4 P4" to split axes with all axex homed I have on the dashboard Z=3.73 and U=206.6
Is this the problem? And if it is how can solve it?
These are my files:
homez.g
homeall.g
config.g
bed.g
Firmware version is 3.1.1
Please, someone could help me?
P.S. Sorry for my english