Posts made by Nothing ever works

Hi, Im a beginner trying to home my custom built delta printer..
When i click on HOME ALL in the dashboard, all three arms come down about 5mm or so and stop there. It is a very odd movement to me because arent the arms supposed to go up until they hit the endstops and then do their thing from there? (Im using normally closed endstops) should i use normally open or does it not make a difference?
When i click on Delta calibration or Run mesh compensation, the arms go down and crash into the print platform and usually thats when i click on Emergency stop.
I will include screenshots of all of the files, if you require more info please tell me.
Thanks for your time and help.

@Phaedrux

I've tried chrome and i get the exact same results, edge doesnt load, firefox is messed up but kinda loads like in chrome.

In YAT it says that the firmware is 2.0 ? I installed the newest firmware on github. I also used M21 to make sure the SD was connected. I downloaded DuetMaestroFirmware.bin and opened the SD and put it directly in sys file on the SD card. I also replaced the config files with one that I configured for a custom delta printer. The contents in the www file is also replaced with the new version of the files.

Is M115 used to ping? because thats what i did as you can see in the images.

The DWC is not loading fully and nothing on the page is functional (the buttons).

Thanks!

So I've got an original duet maestro board and I dont know what to do to connect to the Web Control. I have never used a duet board until now. If you need extra info, please tell me. When I kinda connect to the Web Control, all I see is a messed up page that doesnt work. Im really frustrated at this point and I dont know how to fix this. I will include some images of what the page looks like. It sometimes times out as well.
Thanks for the help!