Done, I know its taken a while, https://www.thingiverse.com/thing:2388496 including a link to a youtube video.
Best posts made by pcsentinel
-
RE: Guide to setting up switching dual extruder system 2in-1outposted in General Discussion
-
RE: Core XYUV configurationposted in General Discussion
Hi Veti, thanks I was actually writing a response when yours came through. It was my lack of understanding. I was using the S2 or H2 command to ignore endstops as I am just commissioning at this stage so don't have any fitted yet. So when you enter G1 X10 S2 when the head is at 0,0,0 then I was expecting a positive X movement only. when I set M564 H0 instead then G1 X10 does exactly what it should. My bad!