Best posts made by Philippe71

With RRF3.5 beta, it is possible to request values or choices from the user in a macro. This is great, but how do you get the value that the user has entered to use in the following lines of the macro. Is this possible?

For example : I ask the user to enter the temperature needed and I would like to setup the new temp by a M104 S

M291 P"Enter the temperature of the head" S5 L150 H480 F300

With RRF3.4.0 B5
thermocouplemax31856 > Works
thermocouple-max31856 > does not work

@dc42
There are 2 Z motors

I went to the customer's site and was able to update by copying the files to the SD card.
Everything is working again, thanks for your help.

@dc42 Unfortunately, I don't have access to the machine or the board. I only have access to DWC via remote maintenance.
In fact, there's a very strange problem:
One of our customers had a problem with a clogged printhead and sent us back the EXP3HC printhead (RRF3: 3.4.4 + 1 Thermocouple board) for maintenance.
We repaired the head and tested it on our bench equipped with a 6HC (RRF3: 3.5.0b4).
The board worked fine on our bench, but when we sent the board back to the customer (his 6HC board is in RRF3: 3.4.5 + thermocouple), a very strange problem appeared:

• As soon as the nozzle temperature exceeds 386°C on the head controlled by its EXP3HC, the machine's chamber thermocouples (connected to its 6HC RRF3.4.5) go into error and display 2000°C (the chamber is not heating).
• If I switch off the head heating: the chamber thermocouples immediately start working again.
• If I turn the head heating back on, the chamber thermocouples peak at 2000°C for less than half a second, then work again until the head temperature reaches 386°C, and then display 2000°C!!!
  Totally incomprehensible...
  It's repetitive and reproducible.