Simple one:
Not a huge deal, but that is someplace I very commonly need that link.
In DWC2, clicking the T0 button to allow preheating it also causes it to be picked up. Addressing this in the e3d ToolChanger setup Dozuki there is a comment:
"You need to untick the boxes in the UI settings which run the toolchange scripts within the UI"
Do comparable buttons exist in DWC2?
It was the IAP file that was messing me up. It asked for the IAP file which did not exist in the 2.05 release. I wasn’t confident enough to mix in the IAP file from the 3.0 release with my 2.05 bin. Reading elsewhere, that is the way to do it.
I’ll try the swapping back and forth approach and see if I can get it working. I do have access to DWC now (after some work...)
@jens55 said in RepRap ver 3 upgrade - oh my ....:
... but thankfully I upgraded on a spare memory card so I can easily revert to the old system.
Is there an easy downgrade path? I got a new duet with my e3d toolchanger and immediately flashed it to the latest firmware (bad habit, apparently). At that point I was dead in the water, as I kept getting javascript-error/disconnect in dwc (and therefore had no easy downgrade path).
In the end, I built/installed duetWebControl 2.0 which resolved the javascript errors, but all the toolchanger scripts need to be updated/modified to work. I'm partway through (it homes now...)
Is downgrading the firmware as simple as uploading the 2.05 version of Duet2CombinedFirmware.bin from https://github.com/dc42/RepRapFirmware/releases/tag/2.05, clicking "upgrade", and rebooting? I have a Duet2Ethernet if it matters.