@alankilian yes, the specific one has yet to be determined. (based on if it is even possible). but lets say D5065 270KV, the dual shaft motor. I'm looking for torque more than speed.

Hi duet fam,

Been looking into the Odrive to control a brushless fan in a custom set up. I have searched here on the forum for information. It either seems to be old or very scattered. looking for firmware config info.

If anyone has a link to a well circulated post regarding this matter it would be greatly appreciated. I plan on using a duet3 board, and it will be intended to control back flow of the extrusion in tandem with a typical stepper motor control.

@phaedrux thanks for that. tried to follow along and couldn't get past connecting to it with yat/pronter face. drivers were loaded, correct com port and baud rate were selected.

Hello friends,

I happened upon an old duet 2 wifi V1.03 that I must have gotten long ago. There is no SD card in it, no clue what firmware is on it. I have no idea where to start. Can anyone help me out?