I found the article about Panel due and preview Prusa Slicer Thumbnails .
It is quite old and it was picked up but I cannot find any information
that it has finally been integrated.
What is the actual status? Was it integrated
Where can I find it.
I am used to work 90% with octoprint and this is a feature I newer want to miss again
and on DWC that is one of the features that should have been integrated for usability reasons.
Thank you in advance
Best posts made by ProntoPrint
-
Prusa slicer preview image integration?posted in PanelDue
-
RE: Ender3 Linear rail conv. ghosting layershift bad layerlinesposted in Tuning and tweaking
Seeing all this different situations out of the geometry I would like to see how every single situation and the ghosting in relation to cornering sharpness accelleration straightness speet fits into the shown results.
Thanks in advance,
will add the M593 faktor to the pre-gecode and see if there ist an improvement
