Solved by the very effient Ooznest lads
Thanks
Bob

Solved by the very effient Ooznest lads
Thanks
Bob

@droftarts there are no lights tryed a diffent cable the same tryied the cable on another network card and all is ok
looks like the network port is dead
Bob

@redpiperbob Is there an image that i can copy to the sd card that will be like the factory image of a Ooznest Workbee?
Bob

@Phaedrux it had 192.168.2.14
Bob

@Phaedrux Yes I got up to step 5 then the board stopped responding I gave the download an hour to complete the step 5 then I cannot get into the web side of things. I am wondering if I damaged the network port somehow. I am very careful when doing any sort of upload.
I have taken the board of the machine to have a close look at the network sub board as the network address seems ok if i look at Yat
Bob

@droftarts Hi Ian just the same
Can I go back to ver 1.07 I backed up the system filse as it is recomeded to but I dont know what other files should be on the SD card for the Workbee
Bob

@droftarts
that is the file config-network.g

@droftarts FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.0 ELECTRONICS: Duet Ethernet 1.02 or later FIRMWARE_DATE: 2020-01-03b3<LF>ok<LF>

Hi Ian thanks for the reply
heres the note you wantedBob

Hi there I hope someone can help I went to upgrade my Duet 2 firmare from 1.07 to 3.4 and everything has gone haywire I cannot ping the ipaddress and if I look in Yat it says the ip is correct ie 192.168.2.14
the firmware says it is at V3.0 for the main and 1.02 for the ethernet.
I am stuck as I cannot gat into the workbee main page. Please help
Bob
PS uploaded files on sd card