Enclosed my config, homeall and Bed.g
I am happy about every suggestion for improvement, as I am only beginning to learn.
Latest posts made by Reichhalter Erich
-
RE: BLTouch Troubleshooting?
-
RE: BLTouch Troubleshooting?
the printer has been running without problems for a long time.
from one day to the next the problem arose.
all morning measuring the X axis -
BLTouch Troubleshooting?
I have the problem that my Bltouch changes the trigger height from left to right.
I leveled the nozzle to zero on X10 Y150 and then had a trigger height of 0.658,
I did the same with X290 Y150, but a trigger height of 0.840.
If I use M561 before printing, the values on my corners fit, as soon as I use Mesh bed leveling it runs into my left bed and it prints too high on the right.Duet wifi
Bltouch
HEVO Rail
DualZ -
BLtouch problem with the trigger value
I have had problems with meshbed leveling for a week.
when I measure the trigger height from the BLtouch I have with
X10 Y150 a height of 0.658 / 0.652 / 0.655
X150 Y150 a height of 0.632 / 0.632 / 0.632
X290 Y150 a height of 0.835 / 0.840 / 0.830
I have the problem that despite mesh bed leveling the pressure on the left goes to bed and on the right is too high and does not hold.CoreXY
Duet 2 wifi
two independent (Z and U) Z axes and two endstops and BLtouch.