Topics created by rew3

@rew3 said in Stop in middle bed compensation or z-offset wrong when rebooted:

@fcwilt
Yes, the wiring to the BLTouch runs alongside the extruder stepper motor's cable in the same cable chain. (it was quite tight before now I bought a wider one because the cables were a bit too much near).

this is how I configured the commands.

M558 P9 C"^zprobe.in" H5 F120 T6000 G31 P500 X0 Y-39 Z0.8

Thanks.

If it were me, as a test, I would find a way to remove the BLTouch wiring from the cable chain to see if the problem goes away.

Frederick

@rew3 I don't see anything in that M122 report that would account for that problem. Here ar4 some suggestions:

Which browser are you using? Have you tried a different browser? When this next happens, connect a laptop running a terminal emulator (e.g. YAT) to the Duet via USB. Then send M122 via USB and save the result. After that, send M122 P104 via USB to run a test of the SD card.